Trained personnel, specialized equipment, and manufacturer support
These key elements along with knowledge of international standards are combined to ensure that your motor is comprehensively tested. We're constantly investing in manufacturer's drives and controls rather than relying on a "one size fits all" system favored by many repair shops. We don't stop testing just because a motors runs - we're not satisfied until we've proven it meets or exceeds the standards set or followed by the manufacturer.
Endeavor Technologies' rigorous testing and documentation procedures ensure not only that your motor runs, but that it runs like new, and lasts like new. Our technicians have received training by motor manufacturers in Japan, Germany, Italy, and the United States. We've coupled this invaluable experience with a formidable array of dedicated test stands and a meticulous inspection and documentation regimen.
Can your repair shop provide you the following about any motor they've repaired?
- Shaft, flange, and pilot diameter runout vs. the manufacturer's true specification
- Motor shaft diameter vs. the ISO tolerance specified by the manufacturer
- Overall vibration levels of the motor at full speed vs. the vibration class specified by the manufacturer
- Vibration spectrums for particularly high speed, or high precision applications?
- Bearing temperatures after stabilization at full speed.
This data and much, much more is recorded and stored in a permanent record. This record serves as your assurance that the motor was comprehensively tested. It also allows us to compare failure information and identify chronic application problems should the motor ever need service again.
Dedicated test stands including drives and controls from:
- Mitsubishi
- Siemens
- Fanuc
- Yaskawa
- Allen Bradley
- NUM
- Control Techniques
- Eurotherm
Liquid cooled and oil lubricated motors are tested under conditions similar to the application with our liquid cooling circuit and oil/air lubrication system.
Our diagnostic instruments include 6kV and 12kV surge and hi-pot testers, 4 channel 500MHz digital oscilloscopes, micro-ohm meters, digital ID and OD micrometers, and much more.
